Processor And Heatsink Installation - Supermicro SuperStorage SSG-610P-ACR12N4H User Manual

3.4 Processor and Heatsink Installation

The processor (CPU) must first be attached to the processor carrier to form the processor
carrier assembly. This assembly gets attached to the heatsink to form the processor heatsink
module (PHM), which is then installed into the CPU socket. Before installing, be sure to
perform the steps below:
•
Please carefully follow the instructions given on ESD precautions.
•
After shutting down the system, unplug the AC power cords from all power supplies.
•
Check that the plastic protective cover is on the CPU socket and that none of the socket
pins are bent. If they are, contact your retailer.
•
When handling the processor, avoid touching or placing direct pressure on the LGA lands
(gold contacts). Improper installation or socket misalignment can cause serious damage
to the processor or the socket, and may require manufacturer repairs.
•
Thermal grease is pre-applied on new heatsinks. No additional thermal grease is needed.
•
Refer to the Supermicro website for updates on processor and memory support.
•
All graphics in this manual are for illustration only. Your components may look different.
Note: All graphics, drawings, and pictures shown in this manual are for illustration only. The
components that came with your machine may or may not look exactly the same as those
shown in this manual.
Chapter 3: Maintenance and Component Installation
Figure 3-2. Xeon Scalable Processor
31