Supermicro SuperStorage SSG-610P-ACR12N4H User Manual page 64

JTPM1/Port 80 Header
The JTPM1 header is used to connect a Trusted Platform Module (TPM)/Port 80, which
is available from Supermicro (optional). A TPM/Port 80 connector is a security device that
supports encryption and authentication in hard drives. It allows the motherboard to deny
access if the TPM associated with the hard drive is not installed in the system. For more
information on the TPM, please go to: http://www.supermicro.com/manuals/other/TPM.pdf.
Power SMB (I C) Header
2
The Power System Management Bus (I
fan, and system temperatures. Refer to the table below for pin definitions.
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate
cable from the chassis to inform you when the chassis is opened. Refer to the table below
for pin definitions.
Trusted Platform Module Header
Pin Definitions
Pin# Definition Pin# Definition
1 +3.3V 2 SPI_CS#
3 RESET# 4 SPI_MISO
5 SPI_CLK 6 GND
7 SPI_MOSI 8 NC
9 +3.3V Stdby 10 SPI_IRQ#
C) connector (JPI
2
Power SMB Header
Pin Definitions
Pin# Definition
1 Clock
2 Data
3 PMBUS_Alert
4 Ground
5 +3.3V
Chassis Intrusion
Pin Definitions
Pin# Definition
1 Intrusion Input
2 Ground
64
Chapter 4: Motherboard Connections
C1) monitors the power supply,
2