Table of Contents
Advertisement
3.2 Accessing the System
The system is fully accessible by loosening the two front thumbscrews and pulling out the drive
drawer completely.
Lever
Pull Out
Removing a Chassis Cover
1. Loosen the two thumb screws on the front of the chassis to unlock the levers on both
sides. Rotate counter clockwise to unlock, clockwise to lock.
2. Pull out the two levers at the same time. This is will pop out the internal drive drawer,
partially exposing the drive trays.
3. Pull the drive drawer out until it stops.
Caution: Except for short periods of time, do not operate the system without the cover in
place. The chassis cover must be in place to allow proper airflow and to prevent overheating.
Chapter 3: Maintenance and Component Installation
Loosen Thumbscrews
then pull out levers
Figure 3-1. Removing the Chassis Cover
30
8 9
10
11
4
5 6
7
0
1
2
3
Lever
Advertisement
Table of Contents
Troubleshooting
