Processor And Heatsink Installation; The Amd Ryzen 7000 Series Processor - Supermicro A+ AS -2015A-TR User Manual

3.3 Processor and Heatsink Installation

The processor (CPU) and processor carrier should be assembled together first to form
the processor carrier assembly. This will be attached to the heatsink to form the processor
heatsink module (PHM) before being installed into the CPU socket. Before installation, be
sure to perform the following steps below:
•
Use ESD protection.
•
Shut down the system and then unplug the AC power cord from all power supplies.
•
Check that the plastic protective cover is on the CPU socket and none of the socket pins
are bent. If they are, contact your retailer.
•
When handling the processor, avoid touching or placing direct pressure on the LGA lands
(gold contacts). Improper installation or socket misalignment can cause serious damage
to the processor or CPU socket, which may require manufacturer repairs.
•
Thermal grease is pre-applied on a new heatsink. No additional thermal grease is needed.
•
Refer to the Supermicro website for updates on processor support.
•
All graphics in this manual are for illustrations only. Your components may look different.
•
Installing the processor does not require a screwdriver. Do not unscrew the processor
socket.
•
Installing the heatsink requires a Phillips #1 screwdriver.
•
When installing the processor and heatsink, ensure a torque driver set to the correct force
is used for each screw

The AMD Ryzen 7000 Series Processor

Chapter 3: Maintenance and Component Installation
25