Start/Stop Of Engine; Procedure To Start Engine - Baroness GM2810A Owner's Operating Manual

b. Lower the mower deck to change the
hole positions, and then temporarily
secure it with the two bolts.
Adjustment With Cutting Height Adjusting Plates_002
1 Handle
2 Bolt
5. After making adjustments at the three
locations, firmly tighten all bolts.
3
Adjustment With Cutting Height Adjusting Plates_003
1 Bolt
2 mower deck
3 Cutting height adjusting plate

Start/Stop of Engine

Procedure to Start Engine

Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.

Start/Stop of Engine

1
2
1wwy8g-002
2
1
1wwy8g-001
Handling Instructions
Important
When restarting the engine after it has been
turned off, wait until the electromagnetic pump
has fully stopped before restarting the engine.
The electromagnetic pump will stop
approximately 7 seconds after the key switch
is turned to the "OFF" position.
Important
Starter operation must take 15 seconds or
less.
If the engine does not start, stop using the
battery for 30 to 60 seconds to avoid
exhausting the battery.
1. Sit on the seat.
2. Make sure that the parking brake is applied.
3. Make sure that the knife rotation switch is in
the "Stop" position.
4. Make sure that the traveling pedal is in the
neutral position.
5. Move the throttle knob halfway from the
"Low speed" position toward the "High
speed" position.
6. Switch the ignition key to the "ON (GLOW)"
position.
Procedure to Start Engine_001
1 OFF
2 ON (GLOW)
3 START
GM2810A
1
2
3
v2e27i-071
Page 5-19