Fuel Filter - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
[3] Loosen the water drain plug and air-
bleeding bolt to drain the water into the
container.
5
4
2
1
Draining of Water Separator_001
1
2
3
4
5
[4] Tighten the water drain plug and air-
bleeding bolt.
[5] Bleed air from the fuel system.
Cleaning of Water Separator
Important
If water contaminates the fuel, the supply
pump and injector will seize due to heat.
Clean the water separator in accordance with
the Maintenance Schedule.
However, when debris has accumulated in the
cup, clean it even before the schedule.
1. Follow the steps below to clean the water
separator.
[1] Stop the engine, and then turn the key
switch to the "OFF" position.
[2] Place a container under the water
separator.
Page 5-14
3
v1spa6-001
Float
Cup
Water drain plug
Element
Air-bleeding bolt
[3] Remove and clean the cup, element and
float.
Replace the element with a new one
when replacement needed.
5
4
2
1
Cleaning of Water Separator_001
1
2
3
4
5
[4] Install the cup, element and float in their
original positions.
[5] Bleed air from the fuel system.

Fuel Filter

Inspection of Fuel Filter
The fuel filter works to remove foreign objects
mixed into the fuel.
When the fuel flow becomes insufficient,
replace the fuel filter if necessary.
1. Make sure that there is no fuel leakage.
2. Make sure that the fuel filter is not damaged
or dirty.
3
v1spa6-001
Float
Cup
Water drain plug
Element
Air-bleeding bolt
Inspection and Cleaning