Engine - Baroness GM2810A Owner's Operating Manual

Parameter Items
￭
The parameters and corresponding information that appear in the monitor display are listed below.
No. Monitor display L
1 ENGINE SPEED
DRIVERS DEMAND
2
ENGINE TORQUE
ACTUAL ENGINE
3
TORQUE
PERCENT LOAD AT
4
CURRENT RPM
ACCELERATOR
5
PEDAL POSITION 1
ENGINE DESIRED OP
6
SPEED
ENGINE COOLANT
7
TEMPERATURE
8 FUEL RATE
9 THROTTLE POSITION THROTTLE
10 BOOST PRESSURE
INTAKE MANIFOLD
11
TEMPERATURE
12 BATTERY POTENTIAL BAT VOLT
BAROMETRIC
13
PRESSURE
14 AMBIENT AIR TEMP
AIR INLET
15
TEMPERATURE
16 TOTAL FUEL USED
TOTAL ENGINE
17
HOURS
ENGINE OIL
18
PRESSURE
INJECTOR
19 METERRING RAIL
PRESS
ENGINE INLET AIR
20
MASS FLOW RATE
DOC INTAKE GAS
21
TEMP
EXHAUST FILTER
22
INLET TEMP
DPF DIFFERENCE
23
PRESSURE
Monitor
Monitor display S
ENG RPM Displays the engine rpm.
DEMAND TQ Displays the torque required by the ECU.
ENG TORQ Displays the actual torque.
LOAD@RPM Displays the engine load factor.
ACCEL PED1 Displays the accelerator sensor opening.
DES ENG SP Displays the engine rpm required by the ECU.
Displays the temperature measured by the coolant
COOL TEMP
temperature sensor.
FUEL RATE Displays the engine fuel consumption rate.
Displays the engine throttle opening.
Displays the pressure measured by the intake pressure
BST PRES
sensor.
Displays the temperature measured by the intake temperature
MANI TEMP
sensor built into the air flow sensor.
Displays the battery voltage.
Displays the atmospheric pressure measured by the
BARO PRES
atmospheric pressure sensor.
AMB TEMP Displays the ambient temperature.
Displays the intake air temperature measured by the air flow
AIR IN TP
sensor.
FUEL USED Displays the total fuel consumption of the engine.
Displays the total time that the ECU is on (time that the key is
ENG HRS
in the "ON" position).
Displays the engine oil pressure measured by the oil pressure
switch.
OIL PRES
While the engine is running: Normal=200 kPa, Abnormal=0
kPa
Displays the fuel pressure in the rail, measured by the rail
RAIL PRES
pressure sensor.
Displays the intake air volume measured by the air flow
AIR RATE
sensor.
Displays the DOC inlet gas temperature measured by the
DOC TEMP
exhaust temperature sensor.
Displays the DPF inlet gas temperature measured by the
EF IN T
exhaust temperature sensor.
Displays the pressure difference before and after the DPF,
DIFF PRES
measured by the differential pressure sensor.
Description of Functions
Description
GM2810A
Page 4-13