Dpf Parked Regeneration Switch; Light Switch - Baroness GM2810A Owner's Operating Manual

DPF Parked Regeneration Switch

Danger Danger
Do not perform DPF regeneration in a location
where fires may occur since it will become
extremely hot around the exhaust outlet
during DPF regeneration.
Important
If parked regeneration is not required, it will
not start even if the switch is pressed.
The DPF parked regeneration switch is located
in the operation panel.
The DPF parked regeneration switch is the
switch for actuating parked regeneration.
When the regeneration icon is blinking, press
the switch to start parked regeneration.

DPF Parked Regeneration Switch_001

1 DPF parked regeneration switch
When parked regeneration starts, Regeneration
icon in the monitor display changes from
blinking to lighting.
2400 RPM
ENG RPM
65 C
COOL TEMP
DPF Parked Regeneration Switch_002
1 Regeneration icon
DPF Parked Regeneration Switch
1
xlfvcz-009
1
100 %
% SOOT
55 %
FUEL LEVEL
xlfvcz-004
Description of Functions

Light Switch

Note:
Depending on the specifications, this function
may not be available.
Caution
The lights provide auxiliary lighting.
Do not travel or operate the machine at night
or under poor visibility.
The light switch is located in the operation
panel.
When the switch is set to the "ON" position, the
lights turn on. When it is set to the "OFF"
position, the lights turn off.
A

Light Switch_001

1 Light switch
A ON (turn on)
B OFF (turn off)
GM2810A
B
1
bnec97-027
Page 4-5