Liquid Leakage; Bolts And Nuts; Mower Deck - Baroness GM2810A Owner's Operating Manual

Liquid Leakage

Inspection of Liquid Leakage
Caution
When performing maintenance on the
hydraulic system, lower the mower decks.
Important
After approximately 50 hours of operation,
some tightened portions may be loosened and
liquid such as oil may leak.
Be sure to retighten the parts.
1. Check the bottom of the machine for
leakage of liquid such as oil, water, fuel,
etc.
2. Locate the leakage and identify the type of
liquid.
Ignoring leakage will cause further trouble.

Bolts and Nuts

Inspection of Bolts and Nuts
Important
A number of bolts are used in each part of this
machine.
Be sure to re-tighten the bolts and nuts,
because they may be loosened at the earlier
stage of the use.
1. Check the bolts and nuts for looseness and
coming off.
2. Check the bolts and nuts for cracks and
damages.
3. Check the bolts and nuts for rust.
4. Check around the bolts and nuts for traces
of rust fluid.
5. Check for unequal bolt length.
6. Check the bolts and nuts for stripped
threads and abrasion.
Inspection of Wheel Mounting Bolt
Important
Tighten the wheel mounting bolts on the
specified torque by using a torque wrench.
1. Check the wheel mounting bolts and wheel
nuts for looseness and coming off.
Inspection and Cleaning
Handling Instructions
2. Check the wheel mounting bolts and wheel
nuts for cracks and damages.
3. Check the wheel mounting bolts and wheel
nuts for rust.
4. Check around the wheel mounting bolts
and wheel nuts for traces of rust fluid.
5. Check the wheel mounting bolts for
unequal bolt length.
6. Check the wheel mounting bolts and wheel
nuts for stripped threads and abrasion.

Mower Deck

Cleaning of Mower Deck
Be sure to clean the mower deck after use.
1. Stop the engine, and then remove the key.
2. Carefully clean the front and back of the
mower deck with water or compressed air.
3. Remove any grass wrapped around the
rotary knife.
GM2810A
Page 5-15