8b-3-7 Seat base assembly
(1)
WMT5DX取扱説明書_EN.indb 153
replacing the lED pC board
This machine uses three lED pC boards.
refer to the procedure below, and replace the lED pC board that corresponds to the malfunction location.
z To avoid electric shock, accidents or injuries to yourself or other people, or damage to the electronic
z
circuits, be sure to turn off the power switch before starting work.
z pC boards are sensitive to static electricity. If a person handles a pC board while
z
charged with static electricity, the parts on the pC board may be damaged. before
handling a pC board, discharge the static electricity from your body; for example, by
touching the surface of grounded metal.
1
Turn off the power switch. (See "7-6-1 Turning the power Switch On" on page 31.)
2
remove the two countersunk torx bolts (M5 x 12), and remove the tail lamp base.
3
Disconnect the connector.
Connector
Tail lamp base
- Must be performed by a technician -
– Must be performed by a technician-
8b. Service
Torx bolt (M5 x 12)
1
2
3
4
5
6
7
8A
8B
9
10
11
12
153
16/03/22 19:55