Replacing The Str3 Pc Board - Bandai Namco MAXIMUM TUNE 5DX PLUS Operation Manual

(4)
Connector
Connector
WMT5DX取扱説明書_EN.indb 111

replacing the STr3 pC board

z To avoid electric shock, accidents or injuries to yourself or other people, or damage to the electronic
z
circuits, be sure to turn off the power switch before starting work.
z pC boards are sensitive to static electricity. If a person handles a pC board while z
charged with static electricity, the parts on the pC board may be damaged. before
handling a pC board, discharge the static electricity from your body; for example, by
touching the surface of grounded metal.
1
Turn off the power switch. (See "7-6-1 Turning the power Switch On" on page 31.)
2
remove the service door. (See "8B-3-2 (1) removing and Installing the Service Door" on page
106.)
3
Disconnect the six connectors.
4
Open the levers at the tips of the four edge supports, and replace the STr3 pC board.
Connector
STR3 PC board
5
To install, align the holes of the STr3 pC board with the edge supports, and press in the pC
board firmly until it clicks into place.
z After replacement, be sure to check the steering operation. z
(See "7-9 Adjustments after parts replacement (GO TO I/F INITIAlIZE)" on page
68.)
- Must be performed by a technician -
<To remove>
STR3 PC board
Edge support
<To install>
8b. Service
1
2
3
4
5
6
7
8A
8B
9
10
11
12
111
16/03/22 19:54