KIP 700 C Series User Manual page 79

3. 1. 7 Unexpected Interruption / Power Shutdown
Normally, the printer cuts the media being used and then will stop in case of a media mis-feed.
For the following unexpected "while in printing" situations, the printer does NOT cut the media and
immediately stops.
 Roll Deck / Fuser Cover / Left Door is opened.
 The printer is turned off.
 The power cord is unplugged.
 Blackout.
In these cases, please follow the instruction below to remove / rewind the remained media in the
path.
NOTE
Please do not open the Roll Deck unless instructed to do so.
Doing so could cause damage on the Cutter Unit in the Roll Deck.
1. Open the Fuser Cover (1).
2. Hold the handle (4) and pull the Feeder Unit (Manual Feeder) (5).
3. Open the Roll Deck (4).
(4-roll model) Open the Upper Roll Deck.
1
4
3-24
While in Printing
3
2
Chapter 3 Error Correction