Advertisement
WARNING
Ground the product with a correct ground source or you may be
electrically shocked.
1. The Power source should be as follows:208V to 240V plus 6% or minus
10%, 50/60Hz, 16A or higher
2. Use a circuit with a dedicated breaker.
3. Install the product as close to the wall outlet as possible.
4. If you wish to move the printer, please contact your service personnel.
1. Do not remove the screw and do not open the cover if not instructed to do
so in this User's Manual. If you ignore this warning, you may be burnt or
receive an electric shock due to a hot item or electrically charged part
inside of the printer.
2. Do not disassemble or tamper with the printer.It may result in a fire or an
electrical shock.
1. Do not plug in the printer into a multi-wire connector in which some
otherequipment is plugged into. It may cause a fire due to outlet
overheating.
2. Do not damage the Power Cord by stepping on or placing heavy items on
it.If the Power Cord is damaged, it may cause a fire or you may receive
an electric shock. REPLACE THE CORD IF DAMAGED!
1. Do not put a flower vase, a flowerpot or any water-filled item on the
product. Spilt water could cause a fire or an electric shock.
2. If the product generates an abnormal smell or noise, turn it off and
unplug it from the wall electrical outlet immediately.
Do not throw the toner into a fire or other sources of heat, as it can
explode.
(4)
Advertisement
Chapters
