Set Normal Mode - HIKVISION DS-2TD6267-75C4L/WY User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Forklift Filter
Enable these functions if there is forklift in the scene, or it may cause false alarm. The filter
level can be adjusted.
Check Display Filtering Status, and an OSD will be displayed when the function is enabled.
Set Filtering Temperature, e.g., set the filtering temperature as 300 °C and forklifts can be
filtered only when their temperature is lower than 300 °C. The function varies according to
different camera models.
Click Restart to restart algorithm library of forklift filter.
Note
Forklift Filter is mutually exclusive with VCA, Ship Detection and Fire and Smoke Detection.
4. Click Save.

3.3.2 Set Normal Mode

This function is used to measure the temperature of the whole scene and alarm.
Steps
1. Go to Configuration → Temperature Measurement → Basic Settings , and check Enable
Temperature Measurement.
2. Refer to Set Thermography Parameters to set the parameters.
3. Go to Configuration → Temperature Measurement → Advanced Settings , and select Normal.
4. Configure the parameters of normal mode.
Emissivity
Set the emissivity of your target. The emissivity of each object is different.
Distance
The distance between the target and the device.
Pre-Alarm Threshold
When the temperature of target exceeds the pre-alarm threshold, and this status keeps more
than Filtering Time, it triggers pre-alarm.
Alarm Threshold
When the temperature of target exceeds the alarm threshold, and this status keeps more
than Filtering Time, it triggers alarm.
Pre-Alarm Output and Alarm Output
Check Pre-Alarm Output and Alarm Output to link the pre-alarm or alarm with the
connected alarm device.
5. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
6. Click Save.
The maximum and minimum temperature will be displayed on the live view.
9