Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Before You Start
You need to activate the camera before enabling the service.
Steps
1. Access the camera via web browser.
2. Enter platform access configuration interface. Configuration → Network → Advanced Settings
→ Platform Access
3. Select Hik-Connect as the Platform Access Mode.
4. Check Enable.
5. Click and read "Terms of Service" and "Privacy Policy" in pop-up window.
6. Create a verification code or change the old verification code for the camera.
Note
The verification code is required when you add the camera to Hik-Connect service.
7. Save the settings.
Enable Hik-Connect Service via SADP Software
This part introduce how to enable Hik-Connect service via SADP software of an activated camera.
Steps
1. Run SADP software.
2. Select a camera and enter Modify Network Parameters page.
3. Check Enable Hik-Connect.
4. Create a verification code or change the old verification code.
Note
The verification code is required when you add the camera to Hik-Connect service.
5. Click and read "Terms of Service" and "Privacy Policy".
6. Confirm the settings.
13.8.2 Set Up Hik-Connect
Steps
1. Get and install Hik-Connect application by visiting https://www.hikmicro.com/en/ . Then go to
Support → Download Center → Software to down load the application.
2. Start the application and register for a Hik-Connect user account.
3. Log in after registration.
92
Advertisement
Table of Contents
