Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Note
Draw three segments of the rule from near to far to cover all of the detection area.
6. Check to enable Filter by Pixel. Then Draw max size and min size rectangles to filter the target
among human, vehicle, animal, and others. Only the target whose size is between the Max. Size
and Min. Size value will trigger the alarm.
Note
You can draw the max. size and min. size rectangles according to the real target in the scene.
●
The recommended size is 1.2 times of the target.
The height of the rectangle is a more important factor as it is the main difference to tell apart
●
a human and an animal.
Click
to copy the same settings to other rules.
●
7. Click Save.
8. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
6.3.3 Set the Scene Auto-Switch
The device support patrol tracking for multiple important scenes. The alarm will be triggered if the
rule is broken during patrol sequence.
Before You Start
Finish scene settings in advance. See Set Detection Scenes and Tracking for configuration
instructions.
Steps
1. Go to VCA → Scene Auto-Switch to configure this function.
2. Set the scene patrol sequence.
Scene Name
Select a scene name from the drop down list.
Duration
Set the dwell time of the scene when doing patrol tracking.
3. Click the up, down arrow to adjust the patrol sequence.
4. Click Save.
6.3.4 Set Polling Plan
Both the optical channel and the thermal channels support the perimeter protection. Set the
working shift for each channel.
Before You Start
The detection scenes and rules should be configured in advance for both channels.
32
Advertisement
Table of Contents
