Outputs - EBS CPX200N Installation And Programming Manual

8.3.3.

Outputs

8.3.3.1. Outputs 1 / 2 / 3
Types of outputs:
 Non-used – Output is inactive
 Alarm – Output is activated when alarm is detected.
 Standby indicator – Output is activated when the assigned partition is armed.
 Power supply fault – Output is activated when power supply fault is detected.
 Communication loss – Output is activated when information transmission to
server is not possible.
 Chirp – The output is activated when arming (1 chirp) or disarming (2 chirps).
The minimum duration of the chirp signal possible to set from the configurator is
40ms. In the case of set time for exit chirp is generated after arming, similarly in
the case of the time for entry chirp is generated after disarming.
 Alarm & chirp – The output is activated when alarm is detected or when
arming/disarming.
8.3.3.2. Partition 1 / 2
The parameter allows assigning particular monitoring partitions to outputs.
CPX200N ALARM CONTROL UNIT – INSTALLER MANUAL 63 / 106