Description Of Screwed Connectors Of The Control Unit - EBS CPX200N Installation And Programming Manual

5. Green "OK" LED
For the detailed description of "OK" LED operation, please refer to chapter 9.
6. Connector of "CONF" Programming Device
"CONF" IDC10 connector allows the control unit configuration using dedicated GD-PROG
programming device and any computer equipped with RS232 port.
7. "PROG" Button for Default Settings Restoration
Pressing the button for 10s during connecting the control unit with power supply will delete
all users and restore the default admin code. Default admin code is 1111.
8. "START" Button for Battery Activation of Control Unit Without the Mains
Power Supply
If the control unit is activated in the situation of power supply fault, press the button after
connecting the unit to the battery.
9. Screwed Connectors of the Control Unit
For detailed information on feeding, input and output connectors, please refer to chapter
3.3.
10. Assembly Holes of the Control Unit (132x61mm hole span)
The above holes are intended for the control unit to be assembled in any type of casing. In
option a dedicated plastic OBDNA casing can be ordered (the casing includes appropriate
230VAC/18VAC transformer).
3.3. DESCRIPTION OF SCREWED CONNECTORS OF THE CONTROL
UNIT
NOTE: Any assembly and installation works shall be carried out with
power supply off and battery disconnected.
CPX200N ALARM CONTROL UNIT – INSTALLER MANUAL 11 / 106