EBS CPX200N Installation And Programming Manual page 93

10.1.3.4. CPSETUSERPASSWORD
Format:
Limitations:
Description
CPX200N ALARM CONTROL UNIT – INSTALLER MANUAL
CPSETUSERPASSWORD=id,password[,adminPassword]
This command only works when sent through an encrypted way, you
must know the administrator password (the user id == 0), id ranging
from 1 to 8 inclusive. The command needs the option "Allow remote user
management" to be set active in the Configurator. Can be executed only
by ATS or administrator. If the command is executed by ATS, specify
asminPassword
Changes the user's password. Id is the user identifier whose password is
changed, the password is his new password and the adminPassword is
the system administrator password. The command returns:
CPSETUSERPASSWORD:EOK,id
It the command is completed sucessfully
CPSETUSERPASSWORD:ENOT_EXISTS,id
If the specified user does not exist
CPSETUSERPASSWORD:EPERMISIONS,id
If the administrator password specified is incorrect
CPSETUSERPASSWORD:ELENGTH,id
If the new password is too short or too long or does not consist of digits
CPSETUSERPASSWORD:ENOT_ALLOWED
If the command is sent via open SMS or the configuration does not allow
remote management of users
CPSETUSERPASSWORD:EFORMAT
If the format of the sent command is incorrect
93 / 106