Control Functions And Setting Up The Machine; Preparing The Machine For Operation And Transport; Placing The In-Feed Conveyor In The Operating Or Storage Position - Hakki Pilke 55 PRO Manual

3. Control functions and setting up the machine

3.1. Preparing the machine for operation and transport

Before arranging the machine for operation and using it, ensure that the operating conditions, detailed in
Section 1.4, are met and review the safety instructions in Section 1.5.
Note! Inspect and clean the machine according to Sections 4.3 and 5.8 before arranging it for transport.
3.1.1.
Place the in-feed conveyor in
the operating position as
follows:
1. Ensure that sufficient
room is available to
lower the
conveyor (approx. 2.5
m).
2. Release lock A in Figure
5 and lower the in-feed
conveyor's support leg
to lower position B, as
shown in Figure 5.
3. Detach locking pin C in
Figure 6, and lift lock D
from its slot. At the
same time, lower the
in-feed conveyor to the
lower position using
winch E.
Hakki Pilke 55 Pro

Placing the in-feed conveyor in the operating or storage position

in-feed
9 / 48
Figure 5.
Translation Version 3-2022