Adjusting The Log Length - Hakki Pilke 55 PRO Manual

3.2.4. Adjusting the log length

The Hakki Pilke 55 Pro features a hydraulic automatic measuring device for cutting firewood, with an
adjustment value of approx. 25 to 60 cm. When sawing, the log limiter plate (B in Figure 16) always moves
approx. 5 cm backwards with the help of a hydraulic cylinder to ensure that the log does not get stuck and
falls freely into the splitting groove. Before splitting, the operator must always ensure that the log is not
oversized and does not connect with limiter plate B (Figure 16), guide plates or other machine components.
1. Press display knob A once to activate the measurement change (Figure 15).
2. Turn the knob until the display shows the correct wood measurement, and press the knob
again to activate the selection and move plate B of the wood measuring device to the
correct position.
3. If necessary, you can adjust the measuring device manually to the left or right using the
buttons at the bottom edge of display G. After the manual adjustment, the measuring
device returns to the value entered in the display (after sawing or splitting).
Hakki Pilke 55 Pro
16 / 48
Figure 15. Log length adjustment
Figure 16. Log measuring device plate
Translation Version 3-2022