Replacing The Saw Bar - Hakki Pilke 55 PRO Manual

5.1.2.
Replace the saw bar, as follows:
1. Remove the cutting chain
according to steps 1–3 of
Section 5.1.1.
2. Remove the beam's fastening
bolts A (Figure 30).
3. Remove fastening plate C
(Figure 31) and remove the saw
bar from the groove.
4. Place the new bar against gear
wheel B, twist it into the groove
and tighten saw bar bolts A.
5. Install the saw chain in place
according to steps 4–6 of
Section 5.1.1.
Hakki Pilke 55 Pro

Replacing the saw bar

Translation
29 / 48
Figure 30.
Figure 31.
Version 3-2022