Hakki Pilke 55 PRO Manual page 12

•
Lower position: The conveyor belt runs backwards (momentary use for
removing a blockage, for example).
F. Speed adjuster for the out-feed conveyor belt
•
Turning the adjuster clockwise (-) reduces the belt's rotation speed, while
turning the adjuster anticlockwise (+) increase the belt's rotation.
•
Affects the out-feed conveyor and the XL Conveyor out-feed conveyor available
as an accessory.
G. Machine's information and control monitor
•
The monitor can be used to adjust the wood measuring device, for example.
See Section 3.2.1
H. Log guide plate control valve
•
Upper position: AUTO: the guide plates are in automatic mode, i.e. the plates
go up and down automatically according to the movement of the saw bar
•
Middle position: OFF: the guide plates are not in use
•
Lower position: UP: manual control of the guide plates to the upper position
(last log, for example)
I. Fine tuning adjuster of the saw bar lowering speed
•
Turning the adjuster clockwise (-) reduces the lowering speed while turning the
adjuster anticlockwise (+) increases the speed.
J. Joystick
•
Joystick to the left/right: the in-feed conveyor
belt runs to the left/right.
•
Joystick forwards/backwards: lowers/raises
the manual control of the log press.
•
Button A: Splitting knife lowered
•
Button B: Splitting knife raised
•
Button C: Activating/cancelling the splitting
function
•
Button D: Performing the cutting function by
keeping the button pressed down:
o The saw performs the cutting motion (the
cutting chain rotates and the saw bar is
lowered to the lower position)
o In addition, the wood measuring device
turns out of the way and the log press is
pressed against the log
o The log guide plates rise up, if control
lever C is in the AUTO position.
o Releasing the button stops the saw chain
and raises the saw bar back up. The
measuring device and the guide plates
also return to their initial position.
Hakki Pilke 55 Pro
12 / 48
Translation
Figure 10. Joystick
Version 3-2022