Adjusting And Using The Splitting Knife - Hakki Pilke 55 PRO Manual

NOTE! The out-feed conveyor's largest operating angle is the topmost position to which the conveyor
can be locked. Do not exceed the maximum operating angle!
3.2.6.
In the Hakki Pilke 55 Pro machine, the splitting knife is adjusted automatically based on the log diameter.
Sensor A in Figure 18 measures the diameter of the log, the machine's software calculates the correct height
for splitting knife B and the cylinder lifts/lowers the knife to the correct height during sawing.
The splitting knife can be manually adjusted with the top buttons on the control handle (Figure 10, A and
B). The splitting knife moves to the desired position and returns to automatic mode upon the next sawing
of a log. Fully manual control is only recommended to be used by those who are experienced in the
machine's operation. The manual adjustment can be activated through the display (Figure 11, E).
Note! An incorrect splitting knife position on manual control may damage the splitting knife!
Hakki Pilke 55 Pro

Adjusting and using the splitting knife

Figure 18.
Figure 19.
Translation
18 / 48
Version 3-2022