Hakki Pilke 55 PRO Manual page 33

33 / 48
10. Finally, adjust the belt to the
correct tension and to run
straight with the help of
adjustment nuts D (on both
sides). First loosen the circled
bolts (total 6 pcs) so that the rear
roller can move. Retighten after
adjustment.
The belt is at the correct tension
when its middle section is raised
approx. 5 cm when the conveyor
is in the operating position. An
Figure 38.
excessively tight belt may be
damaged more easily, and it
places unnecessary strain on the
bearings of the conveyor.
Hakki Pilke 55 Pro Translation Version 3-2022