Lubrication - Hakki Pilke 55 PRO Manual

5.5. Lubrication

The Hakki Pilke 55 Pro features an automatic
central lubrication pump SKF
feeds Vaseline at regular intervals to the nipples
that require the most lubrication. The pump in
Figure 35 is located at the rear of the machine
behind a sheet metal cover. The lubricator
operates on 12 V voltage and the fill level of the
cartridge can be monitored through the
transparent scale on the side of the cartridge.
The SKF MR380 (380 ml) cartridge must be
replaced with a new one immediately once the
lubricator's red light A is lit (Figure 39).
The grease volume can be changed. The
standard setting is 1 month/cartridge. Grease is
only pumped when the machine is connected to
12 V voltage.
Note! Read the central lubrication pump's
separate operating manual and observe its
instructions!
The outputs of the lubricator's distributor are
numbered from one to ten (Figure 40). Their
lubrication targets are as follows:
1. Splitting mechanism slide, operator's side
2. Splitting mechanism slide, opposite side
3. Log guide plate, operator's side
4. Log guide plate, opposite side
5. Log press cylinder
6. Log press, stabiliser
7. Log press, stabiliser
8. Log press, arm
9. Saw drive end cylinder, arm
10. Saw drive end cylinder, base
Hakki Pilke 55 Pro
34 / 48
, which
TLMR201
Translation
Figure 39.
Figure 40.
Version 3-2022