Using The Xl Conveyor Out-Feed Conveyor (Accessory) - Hakki Pilke 55 PRO Manual

3.2.5.
The Hakki Pilke 50 Pro firewood processor's out-feed conveyor belt is driven by a hydraulic motor. To
change the speed of the belt, use adjuster C in Figure 17. Changing the conveyor angle in the lateral
direction is done hydraulically using lever A in Figure 17:
- Lever forwards: the conveyor turns to the left.
- Lever backwards: the conveyor turns to the right.
Note! Always ensure that there is nothing in the way of the out-feed conveyor before turning it!
The angle of the out-feed conveyor is adjusted mechanically with the conveyor winch. Read more about
the use of XL Conveyor in its separate operating manual.
By using lever B (Figure 17), you can stop the conveyor (middle position) and, if necessary, reverse the
conveyor belt for a short distance (approx. 1 m) by pulling the lever back if a piece of wood is stuck between
the conveyor cleaning grille and the upper roller, for example.
Hakki Pilke 55 Pro

Using the XL Conveyor out-feed conveyor (accessory)

Figure 17.
Translation
17 / 48
Version 3-2022