The Correct Tightness Of The Chain; The Oil Channel Must Be Kept Clean; Remove Visible Dirt And Check That Oil Flows From The Channel (Start The Machine And Rotate The "Cutting Flange" By Lowering It); Note! The Right Way - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

Figure 2061c
20.6.3 Installing the chain and the flange
1. Adjust the chain to the
flange

Note! The right way

2. Put the chain onto the
chain wheel and the
flange into the tightening
pin as well as to the
flange fastening bolts
from its groove.
3. Put the blade batten
to the flange fastening
bolts and twist the bolts
almost to the end
4. Tighten the chain
sufficiently from the
tightening bolt (Figure
2061b)
5. Tighten the fastening
bolts of the flange
sufficiently while
holding the flange up.
Hakki Pilke 42 Easy
44 (97)
The oil channel must be
kept clean:
Remove visible dirt and
check that oil flows from
the channel (start the
machine and rotate the
"cutting flange" by
lowering it).
The correct tightness of
the chain:
When pulling the chain
slightly, three slot teeth
are revealed from their
slot.
Figure 2063
Original Version 4