Tractor Drive - Hakki Pilke 55 PRO Manual

3.2.2.
A tractor-powered firewood processor is connected
to the tractor's three-point lifting devices and
cardan shaft. To connect the machine to the cardan
shaft, you have to move protective cover A of the
socket and multiplier gear into a position where it
covers the socket (in combi models).
Connecting the cardan shaft is a task for only one
person. The tractor cabin must be free of people in
order to prevent accidental contact with the
controls while the log splitter is being connected to
the tractor. Check all the connecting devices of the
tractor and the firewood processor before
connecting them. Never use faulty equipment.
The three-pin power cable D (figure 12b) for the
electric controls is connected to socket F (figure 12a)
of the 12V power source. Connect the cooler's
power cable C to socket G of the 12V power source.
Connect input E of the 12V power source directly to
the tractor's battery using a suitable fuse. Please
note! The power requirement is 300 W (25 A) and
the cable must be at least 2 x 6 mm² in size.
When using the cardan shaft, observe any instructions provided by the manufacturer of the shaft. The
machine requires about 22 kW of power, which must be taken into account with regard to the capacity of
the cardan shaft. A suitable cardan shaft is B03 (22 kW/30 hp) Make sure that the connected shaft is locked
to the splined shaft of the multiplier gear. Connect the chain that prevents the turning motion of the
protective cover to slot B. Finally, ensure that all connections are safe and secure. Never use a damaged or
unprotected cardan shaft.
Note! Tractor-powered machines must be attached to the lifting equipment of the tractor.
Note! The starter (Figure 14) only functions when the machine is powered by electricity.
Hakki Pilke 55 Pro

Tractor drive

Figure 12 a.
14 / 48
Translation
Figure 12.
Figure 12 b.
Version 3-2022