Conveyor Maintenance; Replacing And Tightening The In-Feed Conveyor Belt - Hakki Pilke 55 PRO Manual

5.4. Conveyor maintenance

5.4.1.
Replace the in-feed conveyor belt as
follows:
1. Shut the machine down and
disconnect it from its power
sources.
2. Raise and lock the in-feed
conveyor into the transport
position. (See Section 3.1.1.)
3. Move the belt joint to a suitable
height.
4. Disconnect the joint by using
pliers, for example, to pull out
wire A (Figure 31) that holds the
joint together.
5. Remove the old belt.
6. Slide the new belt under the table
through opening B at the side of
the in-feed conveyor's drive roller
until you can pull the belt out
from the other end C.
7. Lead the rest of the belt under the
log press, around the rear roller
and, finally, behind the conveyor.
8. Connect the joint by inserting
wire A into the joint.
9. Turn the conveyor back to the
operating position and tension
the belt.
Hakki Pilke 55 Pro

Replacing and tightening the in-feed conveyor belt

Translation
32 / 48
Figure 35.
Figure 36.
Figure 37.
Version 3-2022