Main Components Of The Machine - Hakki Pilke 55 PRO Manual

to connect the pushbars and drawbars to the machine must be of the correct size, and the appropriate
locking pins must be used to secure them. Road transport with a tractor is prohibited. Only short transport
is allowed if the tractor's lifting capacity is sufficient. Use a transport chassis suitable for road transport.
The machine must be placed in the transport position if it is to be moved more than 5 metres. Exercise
extreme caution when moving the machine in the operating position. Always lower the machine to the
ground when you stop.
Note! Incorrect lifting may cause a hazardous situation or damage the machine.
Note! Road transport of the machine with a tractor is prohibited!

2.3. Main components of the machine

The Hakki Pilke 55 Pro is a firewood processor with fully hydraulic controls. In other words, all of the
machine's functions are controlled hydraulically with operating levers on the machine's control panel. The
guard of the cutting and splitting section is interlocked with the machine's operation: Opening the guard
stops the cutting and splitting functions.
A. In-feed conveyor
B. Control panel
C. Cutting and splitting unit
D. Out-feed conveyor
E. Work platform
Hakki Pilke 55 Pro
8 / 48
Figure 4. Main components of the machine
Translation Version 3-2022