Maintenance Of The Input Conveyor - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

20.4 Maintenance of the input conveyor

Make sure that the input conveyor's lock works when the conveyor is in the transport
position
Check the belt's
tightness when the
conveyor is in the
working position. The
belt is tight enough
when it is able to
transport a log.
If the belt is too tight,
it wears down faster
and reduces machine
power.
If the belt is crooked on
one side, it should be
adjusted to the middle of
the frame and the folding
rolls by tightening the
adjustment nut on the side
to which the belt is being
pulled, or the other way
around, by loosening the
nut on the side to which the
belt should go.
Hakki Pilke 42 Easy
Poikkileikkaus terästä
4 mm
Adjustment nuts
Locking nuts
Figure 204a
Always check the
condition of the
conveyor winch and
pulley belt before
using the machine.
Original
41 (97)
Figure 204b
- Adjusting the belt's
tightness:
The tightness is
adjusted with the screws
at the end of the
conveyor.
- The correct position
of the belt in relation
to the frame and the
folding rolls:
The belt should roll in
the middle of the frame
and the folding rolls.
Version 4