5. Install the winch handle by screwing the handle on the root of the shaft.
Screw the locking nut of the handle on the shaft.
1. Make sure that the winch is locked to the removal conveyor and that hook latch
is intact as shown below.
Hakki Pilke 27
9 (39)
Conveyor Work Position
Original
Tighten the nut evenly
with the winch shaft.
There should be approx. 5 mm
between the nut and the handle
frame.
Winch operation:
When the handle is turned clockwise,
the brake loosens and the strap
tightens on the spool. When the
handle is turned counter-clockwise,
the brake engages and the strap
loosens from the spool.
Hook latch
Version 5-2014