Adjustments; Adjusting The Travel Of The Splitting Beam; Towards The Initial Position; The Stroke Is Shortened - Hakki Pilke OH 27 Instructions For Assembly, Operation And Maintenance

Valve spool
direction

Adjusting the Travel of the Splitting Beam

A turning rod with stoppers is located under the splitting beam. The initial position
and the point of return of the splitting beam from near the splitting blade can be
adjusted by changing the position of these stoppers.
Stopper on the
cross-cut cradle
side

Splitting beam

Towards the
initial position
NOTE! Adjust the extreme positions of the splitting movement so that the
joint lever will work and make the splitting beam reverse from the
splitting blade all the way to its initial position.
Hakki Pilke 27
The joint lever, which controls the valve spool, must
be in its centre position at a 90° angle in relation to the
valve spool.
Protracted
into the splitting chute
34 (39)

Adjustments

The centre position of the joint lever can be
adjusted with the bolt and locking nut at its side.
Original
Stopper on the
splitting blade side
The stroke is The stroke is
shortened lengthened
Version 5-2014