Placing The Out-Feed Conveyor In The Operating Or Transport Position - Hakki Pilke 38 Pro PTO Instructions Manual

3.1.2.

Placing the out-feed conveyor in the operating or transport position

Place the out-feed conveyor in the operating position as follows:
1. Ensure
that
sufficient room
opening the
conveyor.
2. Turn off the machine.
3. Keep lock A open and
lower the
conveyor down with a
winch to its
position.
Note! Leave sufficient
clearance
30 cm) for
discharge opening of
the conveyor.
4. Turn the upper section of
the conveyor
operating position with
handle C at the upper
end.
5. Turn
the
conveyor's support bar B
to the side.
6. Straighten
groove guard E into the
operating position.
7. Use a winch to lift the
conveyor to the desired
angle (max 40°), and use
lock D on the bottom of
the conveyor to lock the
upper section of the
output conveyor in the
operating position.
Hakki Pilke 38 Pro
there is
for
out-feed
out-feed
lowest
(approx.
the
to the
out-feed
splitting
10 / 40
Figure 5.
Figure 6.
Figure 8.
Translation
Figure 7.
Figure 9.
Version 3