Power Up The Host Computer; Verify Leds - OSS -PCIe-HIB616-x16 Manual

3.8

Power UP the Host Computer

Upon "powering UP" the host computer. Three more LEDs on the Host card will illuminate.
Host card
1. CE: Solid green
2. PWR: Blinking 7x + pause
3. CHO -LINK LED: Solid green
Both Target and Host cards will have the LINK LED illuminate as solid green. The LINK LED indicator will vary depending on the PCIe Slot
Generation configured in the BIOS.
3.9

Verify LEDs

After powering ON the host computer, the LINK LED on both host and target card will illuminate as solid green.
x16 configuration (Four x4 Cables connected)
The following LEDs on the Target card will be illuminated (good link between the Host and Target cards).
1. Aux - D9: Solid green
2. LED 3 - D8: Solid green
3. LED 2 - D6: Solid green
4. LED 1 - D4: Solid green
5. LED 0 - D2: Solid green
6. PWR - D10: Blinking 7x + pause, will be blinking when FPGA program is running properly.
7. CE – D11: Solid green. Note: Either solid green or blinking depending on the PCIe Gen on the expansion board.
8. CHO -D1 (Link LED): Solid green
The following LEDs on the Host card will be illuminated (good link between the Host and Target cards).
1. Aux - D9: Solid green
2. LED 3 - D8: Solid green
3. LED 2 - D6: Solid green
4. LED 1 - D4: Solid green
5. LED 0 - D2: Solid green
6. PWR - D10: Blinking 7x + pause, will be blinking when FPGA program is running properly.
7. CE – D11: Solid green. Note: Either solid green or blinking depending on the PCIe Gen on the expansion board.
8. CHO -D1 (Link LED): Solid green
Photos below show fully linked up and functional host and target cards.
One Stop Systems
HIB616x16 (Rev B) |26