Table of Contents
Advertisement
3.6
Install link cable
Connect the PCIe iPass x8 cable between the host and target cards. Plug in the cable to the host card.
Plug in the other end of the cable to the target card. Make sure the cable is firmly latched in to the cable connectors of the card.
Photo below is a block diagram of an OSS expansion unit linked to a host server / computer.
3.7
Turn ON Power Supply
Connect power to the PSU and turn the switch to ON position.
3.8
Power ON the Host system
Turn On the main power of the host computer.
Upon powering ON the Host system, it will send a sideband signal to the Target card triggering the target expansion system to turn
ON.
If the expansion unit or the HIB card are not powering ON, check the link cable make sure it is firmly connected. The target and
host card must be fully seated in the PCIe slot in order to work correctly.
One Stop Systems
OSS-PCIe-BP-2019 | 19
Advertisement
Table of Contents
