The photos below are reference of a x16 PCIe 3.0 slot connector. The specification of the PCIe slot is printed on the board next to connector for
easy identification.
3.5
Connecting the Link Cables
3.5.1
x16 configuration: FOUR cables
Note: Make sure the HIB616-x16 host card is set to x16 configuration, see the x16 switch setting section.
•
Plug-in the 1
st
cable to Port#0 (Top port) on both Target and Host cards
•
nd
Plug-in the 2
cable to Port#1 on both Target and Host cards
•
rd
Plug-in the 3
cable to Port#2 on both Target and Host cards
•
th
Plug-in the 4
cable to Port#3 (Bottom port) on both Target and Host cards
Note: It is easier to plug in the cables from bottom to top.
One Stop Systems
HIB616x16 (Rev B) |21