X4 Configuration: One Cable - OSS -PCIe-HIB616-x16 Manual

Note: The two cables on the TARGET card must remain connected on PORT #0 and PORT #1. See diagrams below as an example.
3.5.3

x4 Configuration: ONE cable

•
Plug-in the single cable to Port#0 (Top port) on both Target and Host cards
You can move the x4 cable on the HOST card to another port. However, the other end of the cable stays connected to PORT#0 on the Target
card.
Photo A1: Cable on the Target card isconnected toPORT #0. The other end of the cable is connected to PORT #1 on the Host card.
Photo B1: Cable on the Target card is connected to PORT #0. The other end of the cable is connected to PORT #2 on the Host card.
One Stop Systems
HIB616x16 (Rev B) |23