3
Installation Procedures
The following steps will guide you through the installation of your OSS HIB616-x16 card.
3.1
Tools Required for Installation
To complete the installation of the OSS product you will need a Phillips-head screwdriver and ESD wrist strap to prevent electrostatic discharge.
3.2
Configure Cards (Host and Target modes)
Set the switches on the card for the desired operating mode. See Host and Target cards configuration section for more details.
Photos below are Host and Target mode settings.
•
The Host card is installed in the host computer.
•
The Target card is installed in the expansion OSS backplane. The card must be installed in a target slot.
3.3
Install the Target card
In this example, install the Target card in a Gen4 OSS backplane.
Do not plug in the Target card while the board or the unit is ON or has power. Disconnect the power first prior to installing the
card.
One Stop Systems
HIB616x16 (Rev B) |19