OSS -PCIe-HIB616-x16 Manual page 37

You can check the Host and Target devices by using the command below.
•
#lspci –vvv | grep c010
The output below shows only the Host card is detected. The Host card is not connected to the Target card / expansion unit.
•
#lspci –vvv | grep c010
The output below shows both Target and Host card are detected, 12 instances of c010 are detected. The Target card is installed in a 2-slot
Passive Backplane.
•
lspci -vvv -s 01:00.0 | grep -i 'LnkSta\|LnkCap\|Physical\|Port'
To check for link speed, link width, physical slot, and port assignment, use the command below.
lspci -vvv -s 01:00.0 | grep -i 'LnkSta\|LnkCap\|Physical\|Port'
lspci –nvvs –01:00.00 | grep 'Capabilities\|Port\|LnkSta\|LnkCap'
One Stop Systems
HIB616x16 (Rev B) |37