3.6
Connect Power to Expansion board / unit
Plug in the power cable to the expansion unit power supplies.
•
All three fans will spin up at low speed (if you have an expansion unit equipped with cooling fans).
•
Seven LEDs on the target card will illuminate.
1.
Aux - D9: Solid green
2.
LED 3 - D8: Solid green
3.
LED 2 - D6: Solid green
4.
LED 1 - D4: Solid green
5.
LED 0 - D2: Solid green
6.
PWR - D10: Blinking 7x + pause, will be blinking when FPGA program is running properly.
7.
CE – D11: Solid green. Note: Either solid green or blinking depending on the PCIe Gen on the expansion board.
LED3, LED2, LED1, LED0, PWR and CE:
AUX LED
3.7
Connect Power to Host Computer
Upon connecting power cable to computer / server, five LEDs on the host card will illuminate.
1.
Aux - D9: Solid green
2.
LED 3 - D8: Solid green
3.
LED 2 - D6: Solid green
4.
LED 1 - D4: Solid green
5.
LED 0 - D2: Solid green
One Stop Systems
HIB616x16 (Rev B) |25