Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 7

Owner's Information
BUTTON BUTTON FUNCTION FUNCTION
GLOWING
EMBERS/
GLOWING
LOGS/
DOWN LIGHT/
SYNC
AMBIENT LIGHT
HEATING
TIMER
-
-
Temperature Sensor
Convection
Display
My Flame Settings
Flame Palette
Glowing Embers/ Glowing Logs/
Downlight/Sync Settings
Heater Settings
Press the button to enter the GLOWING EMBERS settings, press '
through Red - Amber - Yellow - Green – Cyan - Blue – Purple – White – 8 Colour Cycling - Off.
Press '+' and '-' button to adjust the brightness from 10-100%, total six settings including Off.
Press again to enter the GLOWING LOGS adjustment screen.
f g
Press ' ' and ' ' button to cycle through Red - Amber - Yellow - Green – Cyan - Blue – Pink –
White - 12 Colour Cycling - Red/Amber/Yellow - Yellow/Pink/Amber – Cyan/Blue/Pink – Off.
Press '+' and '-' button to adjust the brightness from 10-100%, total six settings including Off.
Press again to enter the DOWN LIGHT adjustment screen.
f g
Press ' ' and ' ' button to cycle through Red - Amber - Yellow - Green – Cyan - Blue – Purple –
White – 8 Colour Cycling - Off
Press '+' and '-' button to adjust the brightness from 10-100%, total six settings including off.
Press the button the fourth time to enter the SYNC, the colours of flame palette, fuel bed, log
burning and down light could be synced.
f g
Press ' ' and ' ' button to cycle through Red - Amber - Yellow - Green – Cyan - Blue – Purple –
White – 8 Colour Cycling - Off
Press '+' and '-' button to adjust the brightness from 10-100%, total six settings including off.
Press the button to enter the AMBIENT LIGHT settings, and the setting will cycle through Cold
White - White - Warm White - Light Amber - Amber - Yellow - Gold Yellow - Red - Green - Cyan -
Blue - Light Purple - Purple -13 Colour Cycling and Off.
Press '+' and '-' button to adjust the brightness from 10-100%, total six settings including Off.
Press the HEATING button, and the heater will cycle the heat setting: AUT - LOW - HIGH - OFF.
The AUTO heating will work after the weekly timer has been set in the MyFlame App.
Press the TIMER button to set the desired time for the fireplace to run.
The Timer can be set 0.5H, 1.0H, and then each hour up to 10.0H.
f g
Press the ' ' and '
corresponding function.
Press the '+' and '-' button to increase or decrease the settings such as the light setting.
OPERATING THE APPLIANCE - ADVANCED OPERATION
Power
Flame Speed
Mood Lighting
Strip (Optional)
Timer Settings
ACTION ACTION
' button to choose different settings such as the colour settings of the
Temperature
Setting
TURN ON/OFF
Press button to turn on the flame effect.
Press button to turn off all the functions under the manual
heating control mode.
Press button to turn off the flame effect under AUTO heating
mode.
f g
' and ' ' button to cycle
Timer
Battery Power
Actual Room
Temperature
Heating
7 7