Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 46

PAIRING THE REMOTE CONTROL TO
THE APPLIANCE
Signal Code
The below operations should be carried out before coding
when changing to a new remote or the unit cannot be
controlled by the remote:
Press the power button until 2 short beeps sound from the unit,
release the button.
1
2
3 seconds
3
Within 10 seconds, press the
finished when 1 long beep sounds from the unit.
Resetting of the remote control is necessary if the
appliance operates wrongly due to external interference
signal and the remote control is not in use.
Open the back cover of the Remote.
Press the Reset button for 3 seconds and reset the coding.
46
SERVICING INSTRUCTIONS
2 Beeps
1 Beep
button on remote. The coding is
ACCESSING THE FUEL BED
The decorative finishing trim (if installed), glass, media will need to
be removed in order to do any maintenance inside of the appliance.
THIS APPLIANCE MUST ONLY BE SERVICED BY A SUITABLY
QUALIFIED PERSON.
BEFORE UNDERTAKING ANY WORK ON THE APPLIANCE:
SWITCH OFF THE APPLIANCE AND ISOLATE THE POWER
SUPPLY ENSURING THERE IS NO POWER TO THE APPLIANCE.
Wait for at least 10 minutes until the appliance has cooled down.
1
2
3
4