Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 6

REMOTE CONTROL
BUTTON BUTTON FUNCTION FUNCTION
POWER
MY FLAME
MAIN FLAME/
FLAME PALETTE
FLAME SPEED
6 6
The POWER button will turn the fireplace on, and enter standby mode.
This will turn on/off all the functions at once but will hold the settings in memory.
Press the MY FLAME button followed by '+' and '-' or '
flame settings.
Flames 1-6 are default settings, 7-9 can be saved as custom settings.
Press the MAIN FLAME button to enter the main flame effect adjustment screen, press '
g
' ' button to cycle through Red - Amber - Yellow - Green – Cyan - Blue – Purple – White – 8
Colour Cycling - Off.
Press '+' and '-' button to adjust the brightness from 10 -100%, total six settings including Off.
Press again to enter the FLAME PALETTE adjustment screen. Press '
through Red - Amber - Yellow - Green – Cyan - Blue – Purple – White – 8 Colour Cycling - Off.
Press '+' and '-' button to adjust the brightness from 10 -100%, total six settings including Off.
Press the button to enter the FLAME SPEED settings.
Press '+' and '-' button to adjust the speed by five settings.
Owner's Information
The remote control should be left on
a flat surface in the room where the
appliance is installed and away from
any direct flow of hot air.
ACTION ACTION
f g
' and ' ' , the unit will cycle through 9
f
' and '
f
' and
g
' button to cycle