Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 12

OPERATING THE APPLIANCE -
TROUBLESHOOTING
BATTERY
The battery power level is indicated at the top right of the remote
control screen.
Battery Full
Battery Half Power
Battery Empty
NOTE: The remote control has a Battery Status
indicator (top right corner), after an extended
period of displaying empty the LED screen will
cease to function despite the handset still being
able to send commands.
Replace the batteries to restore display.
BATTERY REPLACEMENT
Exhausted batteries are to be removed from the appliance and
safely disposed of.
Slide Cover
Lift Cover
Ensure that the handset batteries are new and inserted correctly.
Dispose of old batteries at an appropriate recycling facility.
Battery replacement is recommended after 1 year.
The Remote requires two 1.5V alkaline AAA batteries.
12 12
No action required
Ensure new batteries are available.
Replace batteries immediately
2 x AAA
2
1
-
2
+ -
Owner's Information
Ensure the correct polarity.
Do not short circuit the terminals.
Do not attempt to recharge non-rechargeable batteries.
Remove rechargeable batteries before charging.
Do not mix old and new batteries.
Remove batteries if the appliance is not used for long periods.
NOTE: To use both remote and manual functions
the manual on/off switch must be in 'ON' position.
In order to prevent the product becoming too hot,
there is 10s delay when turning on the heater and a
10s delay when turning off the heater fan.
The manual button controls basic functions, not a
full range of controls. Use the remote hand set to
carry out all functions.
HEATER RUNNING INDICATORS
When the fan heater is used in conjunction with the flame or
fuel bed effects the heater running indicators will light up for 10
seconds.
The LEDs will illuminate for 10 seconds if the flame or fuel bed
effect is On.
If the fan heater is used independently, the heater running
indicators will stay on.
IMPORTANT: If the handset loses signal or needs to be
replaced, see Servicing Instructions for details.
RESET BUTTON FOR REMOTE CONTROL
1
+
2
1
3 seconds
2 Beeps