Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 24

WALL MOUNTING BRACKET (OPTIONAL) WALL MOUNTING BRACKET (OPTIONAL)
The wall mounting bracket will be located at the rear of
1
the appliance and is held in place by 2 brackets at base of
appliance.
Tilt appliance forward to gain access to the 2 brackets.
Remove 2 screws at base of appliance securing the bracket
and discard brackets. Reinstall screws.
Lift up and out to remove wall mounting bracket from rear of
appliance.
INSTALLATION
Mark the wall to the desired height using the wall mounting
1
bracket as a guide. Ensure that at least 2-3 studs are found
to support the wall mounting bracket as the weights of these
units will vary. Also ensure wall mounting bracket is level.
Note: There is also wall plugs/screws supplied if required.
24
PRE-INSTALLATION
Hook appliance onto the wall mounting bracket as shown
2
above.
3
Appliance attached to wall.