Regency Fireplace Products Onyx EX110 Instructions For Use & Installation page 18

Maximum power consumption: 120VAC 15 Amp 60Hz
A 1.8 m (72'') lead with plug is supplied.
2 x Remove control handset battery (AAA).
IMPORTANT: A 15 amp, 60Hz 120 Volt circuit is required for installation of this Appliance. A dedicated circuit is not required, but is highly
recommended to prevent circuit breaker from tripping or fuse failure. Failure to provide adequate power to this Appliance will void your warranty.
NOTE: If hard wiring to the Appliance, this must be completed by a qualified electrician. Failure to do so will void your warranty.
The wiring from the appliance to the breaker must be supplied by a qualified electrician. This is not supplied with the appliance
Onyx Electric
LED ELECTRIC FIRE RANGE
with Thermostatic Remote Control
Models: Onyx EX110/EX150/EX190
Instructions for Use & Installation
For use in US (United States) and CA (Canada)
IMPORTANT
Please read these instructions carefully before
installation.
Failure to follow them could result in serious injury.
THE HEATER OUTLET GRILLE BECOMES
VERY HOT WHILE IN OPERATION.
DO NOT COVER THE OUTLET GRILLE OR SAVE THESE INSTRUCTIONS: Leave this manual
with the appliance, they will be needed when
ANY PART OF THE APPLIANCE.
maintenance or servicing is required.
920-651 For use with 120V 60Hz electricity supply.
THIS APPLIANCE MUST BE GROUNDED. 02.23.23
x1
EX110 x3
EX150 x4
EX190 x5
Not shown and supplied are wall plugs,silver screw for wall plugs and black wood screw to secure nailing strips.
Hardware
Software
Frequency
Maximum Transmit Power
18
TECHNICAL SPECIFICATION
Onyx EX110
Onyx EX150
Onyx EX190
x2 (AAA)
x1
1 x Power Cable
x2
x2
x2
CONTROL SYSTEM TECHNICAL DATA
Main Control Board
RC01-059 A00 V0.
RC01-059 A02 V0
FSK 433. 92MHz
10mW
1500 Watts
1500 Watts
1500 Watts
PACKING LIST
EX110 x4
EX150 x6
EX190 x6
x1
Remote Receiver Board
WBR3 V1.0
-
2.4GHz
100mW
x1
x1
x1
Remote Control
RF290H V1.1
RCS19-V01.06
FSK 433. 92MHz
10mW