Thunderbolt Interface Card Installation - Magma Roben-3TX User Manual

Thunderbolt Interface Card Installation

The following steps are applicable on how to replace and install a Thunderbolt Interface card.
1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable
from Expansion chassis or from computer.
2. Unplug the Interface power cable from Thunderbolt Interface card. Unscrew to remove the
interface card.
3. Plug-in the Thunderbolt Interface card in PCIE slot#0. This is the designated slot for the interface
card. Installing the Interface card in a non-designated slot will cause the system to malfunction.
4. Plug-in the power cable Thunderbolt Interface card. Secure the interface card.
Roben 3 | Chapter 4 Advanced Technical Information
Magma
37