Fröling SP Dual compact 15 Operating Instructions Manual page 4

Checking the draught controller flap
Cleaning the induced draught fan
Clean the heat exchanger pipes
Cleaning the grate and combustion chamber
Checking the seal on the doors
5.4 Maintenance work by technicians
5.4.1 Checking and cleaning the combustion grate
5.4.2 Cleaning the measurement line of the underpressure controller
5.4.3 Cleaning the Lambda probe
5.5 Servicing the condensing boiler heat exchanger (optional)
5.5.1 Inspecting the heat exchanger
5.5.2 Checking the condensation drain
5.6 Emissions measurement by chimney sweep or regulatory body
5.6.1 Starting the emissions measurement in pellet mode
5.6.2 Performing the emissions measurement in firewood mode
General information on measurement
Create the measurement conditions and perform the measurement
5.7 Replacement parts
5.8 Disposal information
5.8.1 Disposal of the ash
5.8.2 Disposal of system components
6 Troubleshooting
6.1 Carbonisation gas duct flap is stiff
6.2 General fault with power supply
6.2.1 Behaviour of system after a power failure
6.3 Extra cleaning of flue gas paths
6.4 Excessive temperature
6.5 Faults with fault message
6.5.1 Procedure for fault messages
7 Appendix
7.1 Addresses
7.1.1 Address of manufacturer
Customer service
7.1.2 Address of the installer
4 Fröling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com
Contents
60
60
61
63
63
65
66
68
68
69
69
71
72
72
73
73
73
74
74
74
74
75
75
76
76
76
78
78
79
80
80
80
80
80